TLR5T Timken Lubricant Ring Block Testing Machine

1)Introduction:

The Timken ring block testing machine is a new type of lubricating oil friction and wear testing machine, which mainly realizes the sliding friction of the ring block, which can change the lubrication state (oil lubrication or grease lubrication), load, speed and other parameters. The test of the bearing capacity and the value of the lubricating oil is carried out to evaluate the extreme pressure performance of the lubricating oil. At the same time, the ring block testing machine can also be used to test the wear resistance of various metal materials and non-metal materials (nylon, plastic, etc.) under sliding friction state, and also can measure the friction of various materials and calculate The coefficient of friction of various materials.

2)Main functions and features:

This type of friction and wear tester uses a new manufacturing process and control technology. The test force is applied smoothly and reliably; the control of the spindle's speed, number of revolutions, test force, friction torque, friction pair temperature, and test time are simple and stable. The advantages of products are as follows:

1. Drive mode: This type of test machine is driven by servo motor, with strong controllability and low failure rate. After years of continuous improvement, the performance is stable and reliable, ensuring the accuracy of real-time tracking measurement of test force and friction force;

2. Main structure: When the friction test is carried out, the influence of vibration of the motor and accessory parts on the wear marks should be reduced. Therefore, we use the whole body, thickened support plates and precision bearings;

3. Electrical part: The equipment adopts independent industrial controller and module, which can effectively ensure the influence of high speed or oil film rupture on the performance of the control part.

4. Service team: We are not only the manufacturer of this type of equipment (many manufacturers assemble without precision according to the old drawings), but also have independent technical service departments (more than 100 research institutes for research and development of friction and wear test machines for many years). The problem can be solved and solved in real time. At the same time, our testing machine-research and exhibition center invested in the national new material industrial park provides a stable base for the company's later research and development.

3)Main technical parameters and specifications

4)Basic system configuration

5)Timken ring block tester principle

The Timken Friction Tester was developed by the Timken Company for testing lubricants and greases from 1935 to 1972. It is mainly used to test the bearing capacity of lubricating oil and distinguish the extreme pressure performance of lubricating oil. The extreme pressure performance is indicated by the OK value. A steel test ring is rotated by a test shaft on a steel test block, the test ring is mounted on a horizontal shaft, and the test block is mounted in the test block. The lubricating oil flows to the sample ring at a certain temperature, and the sample ring rotates by the spindle of the testing machine. The pressure between the test ring and the test block is subjected to pressure. By observing the surface scratches and scratches on the test piece, it is possible to obtain the scratch without scratching. Maximum load OK value.

a. Used to evaluate the friction properties of lubricating oils and greases

b. Complete extreme pressure, wear and friction performance tests

c. Complies with GB11144 ASTM D2782 ASTM D2509 IP 240 IP 326 related standards

d. Configure the safety shield

e. With automatic loading device

f. can be equipped with grease automatic sampler

g. Adjustable test speed

h. Adjustable loading speed

i. Automatic grease injection

j. Lubricant feed tank volume 3.8L, built-in circulating heat pump.

k. Test microscopy can test specimen scratches

6)Installation requirements:

l. Laboratory: the door is 2 meters high and 1.5 meters wide, and the equipment covers an area of about 10m2;

m. Floor: The load capacity needs more than 1 ton;

n. Power supply: three-phase four-wire (three fires and one zero) 380V (16A) four-core socket set, 220V (16A) three-core socket set, and a ground connection;

o. If it is necessary to test the water for a long time, it is required to have a water source;